Bosch SmartGrow MSGP6, Инструкция по эксплуатации

Страница: 10 / 115

10
en Overview
Use
Starting growing
Notes:
– Do not install in direct sunlight, near to
air conditioning and heating appliances
or outside. If the ambient temperature
is too high (approx. 36-40 °C), the
light unit will light up red. At over
40 °C the appliance will then switch
off. Do not place on vibrating surfaces
(e.g. washing machines).
– We recommend planting plants that
take the same amount of time to grow
together. The growth timelines are
shown on all packaging.
MSGP6 X Image sequence
B
MSGP3
X
Image sequence
C
1. Place the tray on an even surface.
2. Mix the nutrient solution. 1 measuring
spoon (2 g) of nutrients in 1 litre of
water. Then seal the nutrient packaging
(zip-lock bag) so that it is airtight.
Important: Please follow the dosage
recommendations to ensure optimal plant
growth.
Capacity / nutrient solution
MSGP3 max. 1.0 l + 2 g
MSGP6 max. 3.0 l + 6 g
3. Pour the nutrient solution into the bowl.
When doing so, do not exceed the
marking for the maximum capacity.
4. Place the assembled watering unit onto
the tray and put plant capsules in all
empty openings.
Note: If the watering unit is not assembled,
follow steps 14. and 15. first.
5. Carefully remove the cover from the
plant capsules so that the seeds do not
fall out and do not stick to the cover film.
6. Insert the plug into the pump’s power
connection.
7. Place the light unit onto the connector
unit of the pump without height modules.
Pay attention to the guide slot when
doing so.
Overview
X Fig.
A
1 Light unit
a Sensor (MSGP6)
b Button (MSGP3)
2 Height modules (2 units)
a Guide slot
3 Pump with connector unit
a Marking
b Marking
c Power connection
d Guide slot
4 Plant tray
a Marking
b Openings for plant capsules
c Filling opening for nutrient solution
5 Watering tray
6 Bowl
a Marking (maximum capacity)
7 Plug-in power supply unit
8 Measuring spoon
9 Capsule set *
a Plant capsules
b Nutrients
* Not included in the delivery.
Before using for the
first time
Before the new appliance can be used, it
must be fully unpacked and checked.
■ Remove all parts from the packaging
and dispose of all packing materials.
■ Remove the light unit and watering unit
(watering tray with plant tray and pump).
■ Remove other accessories from the
water bowl.
■ Check that all parts are present and
examine them for obvious damage.
X Fig.
A
■ The height modules will not be required
until later.