13
Operating the Dishwasher
Start the dishwasher
1
Open the door and press the
[On/Off]
button. The LED of the last selected cycle flashes.
2
Select a cycle and desired options.
3
Press
[Start]
and close the door to begin the cycle.
Cancel a cycle
1
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press and hold the
[Start]
button for approximately 3 seconds until the display reads
“0:01”.
3
Close the door and wait about 1 minute while the dishwasher drains.
4
Open the door and press the
[On/Off]
button.
Interrupt a cycle
1
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the
[On/Off]
button to turn the unit off.
3
To resume the cycle, press the
On/Off
button and close the dishwasher door.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
r:05
”.
5
Press the “
C
” button to select the desired setting.
“
r:00
” = dispenser is OFF
“
r:01
” = lowest setting
“
r:02
” = low setting
“
r:03
” = medium setting
“
r:04
” = medium/high setting
“
r:05
” = high setting
“
r:06
” = highest setting
6
Press
[Start]
to save the setting and close the door.
InfoLight
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 4) and press
[Start]
until the display indicates “
H:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
1:01
”.
5
Press the “
C
” button to switch between “
1:01
” = ON and “
1:00
” = OFF and press
[Start]
to save.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Open the door and press the
[On/Off]
button.
2
Press the
[+]
button until the display jumps to “
h:01
”.
3
Press the
[+]
or
[-]
button until the displayed time corresponds with your requirements.
h:01
= 1 hour delay
h:24
= 24 hour delay
4
Press
[Start]
to activate delay start.
To cancel delay start:
1
Press the
[+]
or
[-]
button until “h:00” is indicated on the digital display.
2
Press
[Start]
to save setting and close the door.
