en-us
Operating the Dishwasher
30
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press
On/Off
button
(
.
2.
Turn off water supply.
3.
Remove the utensils when they
have cooled down.
9
WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Press
On/Off
button
(
.
The LED’s go out. The wash cycle
is saved.
2.
To continue the wash cycle, close
the door and press
On/Off
button
(
again.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button
P
again.
Terminating the wash cycle
(Reset)
Terminati
ng the wa
sh cycle
1.
Press and hold
Start
button
P
for approximately 3 seconds until
the display reads
‹
:
‹‚
.
2.
Wait about 1 minute while the
dishwasher drains.
3.
Press
On/Off
button
(
.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the
Start
button
(
has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Child Lock (panel lock)
The child lock will lock the panel
while the dishwasher is in operation
to prevent that a wash cycle is
interrupted unintenionally (e.g. by
children).
To set the panel lock:
1.
Start the desired wash cycle.
2.
Hold down the button that says
‘Child Lock’ underneath it for
approximately 3 seconds until the
display reads
’–
.
The panel lock is active.
’–
will be indicated now if any button
is pressed and the program will not
be reset.
To
deactivate
the panel lock hold
down the button that says ‘Child
Lock’ underneath it for approximately
3 seconds until the display no longer
reads
’–
.
The panel lock is deactivated
automatically when the wash cycle is
completed. In case of a power
outage the panel lock will remain
active. The panel lock has to be
activated with each new wash cycle.
Содержание SHE863WF2N
Страница 1: ...en us Operating instructions fr ca Notice d utilisation Dishwasher SHE863WF2N SHE863WF5N SHE863WF6N ...
Страница 2: ...2 ...
Страница 90: ......
Страница 91: ......