24
Dishwasher
not filling
with water
or “Check
water sup-
ply” display
lights up
1. Restriction in the water supply
system
2. Previous wash cycle was not com-
pleted
3. Delay start is active
4. Household water supply turned off
1. Ensure that the water supply valve
(typically located under kitchen sink)
is open and check that the water sup-
ply line has no kinks or clogs
2. Refer to the “Operating the Dish-
washer” section of the manual.
3. Cancel the delay start or wait until
delay start time completes
4. Turn on water supply
Fascia panel
discolored
or marked
1. Abrasive cleaner used
1. Use mild detergents with soft
damp cloth
Water leaks
1. Suds
2. Door seal could be pulled away
from track
3. Condensation vent is blocked
4. Improper installation
1. Wrong type of detergent results in
suds and leaks - use only dishwasher
detergents. If suds still persist, add
one tablespoon of vegetable oil at
the bottom of the dishwasher and
run the desired cycle.
2. Ensure the door seal is in the track
3. Ensure that condensation vent is
not blocked
4. Have proper installation verified
by qualified personnel (water supply,
drain system, leveling, plumbing)
Tub stains
1. Stains on the dishwasher interior
are due to water hardness
2. Silverware in contact with tub
1. Concentrated lemon juice can
reduce the build up of hard water
stains. Run Normal cycle until it
flushes and interrupt the cycle and
then place an 8oz. cup of the con-
centrated lemon solution on the
upper rack and finish the cycle. This
can be done periodically to avoid
build up.
2. Ensure that silverware does not
make contact with the tub while run-
ning a cycle.
Noise dur-
ing wash
cycle
1. Dishes may not be arranged
properly
1. Water circulation sound is normal,
but if you suspect items are banging
into each other or into the spray
arms, refer to the “Loading the Dish-
washer” section of the manual for
optimal arrangement.
Problem
Cause
Action
