18
3
Press the “
A
” button until the display shows “
b:02
” for models with a display. For models without a display, the “Clean”,
“Sanitized”, and “Add Rinse Aid” LEDs are all blinking.
4
Press the “
C
” button to increase or decrease the tone. See settings below:
“b:00”
or 0 LEDs blinking = Cycle Completion Signal OFF
“b:01”
or 1 LED blinking = Low tone volume
“b:02”
or 2 LEDs blinking = Medium tone volume
“b:03”
or 3 LEDs blinking = High tone volume
5
Press
[Start]
to save setting.
Infolight®
NOTE: Setting can only be changed for models with a display.
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
1
Press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start]
until the display indicates “
d:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
1:01
”.
5
Press the “
C
” button to switch between “
1:01
” = ON and “
1:00
” = OFF and press
[Start]
to save.
Auto Power Off
NOTE: Setting can only be changed for models with a display. For models without a display, the default setting is P:00
To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. This setting can be adjusted from P:00 to
P:02.
To change the setting:
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button (see page 17)and press [Start] until the display indicates “d:0x” (x can be any number).
Release both buttons.
3
Press the “A” button until the display indicates “P:0x”.
4
Press the “C” button until the display corresponds with your requirements.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5
Press [Start] to save the setting.
Care and Maintenance
A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents possible future
problems.
Overall condition of the machine
Never use a steam cleaner to clean your dishwasher. The manufacturer is not responsible for any consequential damage.
Regularly wipe the front of the appliance with a damp cloth - water and a small amount of liquid soap is adequate. Do not use
sponges with a rough surface or abrasive detergents, as these could scratch the surfaces.
Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or chlorine based cleaners. Use a stainless steel
polish to seal and protect the surface.
Clean the outer edges of the inside door panel regularly to remove debris that may collect from normal loading. If spots begin
to appear on the stainless steel, make sure the rinse agent is full and functioning properly.
Use caution when removing parts for cleaning as some debris may be sharp.
WARNING
