17
Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start]
until the display indicates “
d
:0
0
”
(x can be any number).
3
Release both buttons.
4
Press the “
A
” button until the display shows “
r:05
”.
NOTE: For models without a display, press the “A” button until the LEDs for
“Clean” and “Add Rinse Aid” are blinking.
5
Press the “
C
” button to select the desired setting.
“
r:00
” or 0 LEDs blinking = dispenser is OFF
“
r:01
” or 1 LED blinking = lowest setting
“
r:02
” = low setting
“
r:03
” or 2 LEDs blinking = medium setting
“
r:04
” = medium/high setting
“
r:05
” = high setting
“
r:06
” or 3 LEDs blinking = highest setting
6
Press
[Start]
to save the setting.
Child Lock
NOTE; Only front-control models have Child Lock.
1
After starting a cycle you can activate the Child Lock.
2
Press and hold the
C
button until the display reads “CL” (models with display) or the “Child Lock” LED illuminates (mod-
els without display).
NOTE: “CL” disappears from screen when button is released.
3
Child Lock is now active and buttons will not function, except On/Off.
4
To deactivate, press and hold the
C
button until the “Child Lock” LED turns off or “CL” disappears from the display.
Delay Start
For models with a display, you can delay the start of the cycle in one hour increments up to 24 hours. For models without a
display, you can delay the start of the cycle in three hour increments up to 9 hours.
To set delay start:
1
Press the
[On/Off]
button.
2
Press the
[Delay]
button until the display jumps to “
h:01
” or the corresponding LED blinks.
3
Press the
[Delay]
button until the delay time corresponds with your requirements. For models with a display, the display
can be interpreted as follows:
h:01
= 1 hour delay
h:24
= 24 hour delay
4
Press
[Start]
to activate delay start.
NOTE:
Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
To cancel delay start:
1
For models with a display, press the
[Delay]
button until
“h:00”
is indicated on the digital display. For models without a
display, press the
[Delay]
button until no LEDs are blinking.
2
Press and hold
[Start]
for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE:
Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
Cycle Completion Signal
1
Press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start]
until the display indicates “
d:00
”. Release both buttons.
