1 690 386 051
2020-10-22
|
Robert Bosch GmbH
Symbols used | SCT 415 S52 | 29
1. Symbols used
1.1
In the documentation
1.1.1
Warning notices -
Structure and meaning
Warning notices warn of dangers to the user or people
in the vicinity. Warning notices also indicate the con-
sequences of the hazard as well as preventive action.
Warning notices have the following structure:
Warning
symbol
KEY WORD – Nature and source of hazard!
Consequences of hazard in the event of failu-
re to observe action and information given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observan-
ce:
Key word
Probability of
occurrence
Severity of danger if inst-
ructions not observed
DANGER
Immediate
impen-
ding
danger
Death
or
severe
injury
WARNING
Possible
impending
danger
Death
or
severe
injury
CAUTION
Possible
dangerous
situation
Minor
injury
1.1.2
Symbols in this documentation
Symbol Designation
Explanation
!
Attention
Warns about possible property damage.
i
Information
Practical hints and other
useful information.
1.
2.
Multi-step
operation
Instruction consisting of several steps.
e
One-step
operation
Instruction consisting of one step.
Intermediate
result
An instruction produces a visible inter-
mediate result.
"
Final result
There is a visible final result on com-
pletion of the instruction.
1.2
On the product
!
Observe all warning notices on products and ensure
they remain legible.
en
2. Important information
Before commissioning, connecting and operating
Bosch products, it is absolutely essential to
read the entire operating instructions carefully, es-
pecially the safety instructions. By doing so, any uncertain-
ties in handling Bosch products and the associated risks
are avoided in the interests of your own safety and of pre-
venting damage to the products. If a Bosch product is
handed over to another user, the operating instructions, the
safety instructions and the information on the intended use
must be handed over as well.
2.1
Intended use
¶
The SCT 415 S52 is intended for static calibration of
sensors and cameras on vehicles only. The repair and
service instructions specific to the make apply. Any other
or additional use is not considered the intended use.
¶
The SCT 415 S52 must only be used by trained and
briefed personnel. The manufacturer (Bosch GmbH)
assumes no liability for any damage arising from impro-
per, incorrect or negligent use.
¶
Make sure operating and safety instructions are always
close at hand at the operating site.
¶
Observe all the safety instructions and hazard warnings
on the SCT 415 S52, and make sure they are always
complete and clearly legible.
¶
Operate the SCT 415 S52 and the accessories required
for testing only within their specific work context.
¶
Before using the SCT 415 S52, make sure the test
equipment is correctly set up and connected.
¶
Observe the test/maintenance intervals that are either
mandatory or specified in the operating instructions.
¶
Never perform maintenance work during operation.
Switch off the device before performing maintenance
work.
¶
Follow the instructions for switching the device on and
off specified in the operating instructions along with the
notes for repairs when performing any work!
¶
Indoor use only.
Содержание SCT 415 S52
Страница 2: ......