Bosch Rexroth WSC60GK, Инструкция по эксплуатации

Страница: 70 / 74

70/73 Bosch Rexroth AG R911345359 | WSC60GK/HA/ST
Troubleshooting
14 Troubleshooting
The units are sturdily built. Nevertheless, disturbances may occur in exceptional
cases:
•
by wrong electrical connection or overvoltage in the mains,
• by insufficient cooling, maintenance or overload,
•
by exceeding the maximum current values (parametrization) or
monitoring values.
When an error has occurred, the timer will be inhibited. In this condition,
no welding schedule is possible until the error has been reset.
If warnings are present, welding is still possible.
For PSI 6x00 and PST6x00 timers:
In case of fault, the green “READY” LED is extinguished on the front
panel of the weld timer.
For PSI 6xC0 weld timer:
In case of fault, the diagnosis module shows the fault number.
A list of all error and status messages is provided in the online help of
BOS 6000 .
There you will also find information on error elimination in addition to
the possible causes.
Both faults and warnings may be ”self
‐
resetting” or ”non-self
‐
resetting”.
”Self
‐
resetting” means that events are automatically reset by the timer
when the cause of the fault or the warning has been corrected.
Therefore, they do not require a manual fault reset.
15 Technical data
Technical data to
• tightening torque for screws and clamps
•
storage temperature range
•
fluctuations or deviations of the mains voltage from the rated value
•
inlet temperature and suitable coolant with water cooling
are provided in the technical data of the PSI6000, PST6000 Instructions, refer to
Table1 Required and supplementary documentation.
The weight is calculated from the weight of the respective timer (refer to technical
data Instructions PSI6000, PST6000, Table 1) plus the weight of the cabinet
provided in the circuit diagram or delivery documents.