Bosch Rexroth Tightening System 350, Руководство пользователя

Страница: 301 / 641

3 608 878 300 Tightening Technology | Bosch Rexroth AG 301 /641
System 350 | 3 608 878 300/2019-03
6.4.4.5 Results output on the communication unit (for applications and single-channel tightenings)
The results output can be configured flexibly. As the storage space is limited, the results selection must
be adjusted as specifically as possible to the planned tightening processes (applications and single-
channel tightenings). The configuration is effectively implemented with the following steps:
Applications 1. Selection of the application blocks (FO) the results of which should be output.
2. Determination of the channel results to be output (same for all participating tightening channels in
the application).
3. Determination of the application results to be output (same for all application blocks).
Single channels 1. Selection of the tightening channel's single channels for results output.
2. Determination of the single-channel results to be output.
Field bus master
checking/
configuration
1. Check the assignment of the send range in the field bus module.
2. Configuration of the field bus master for the selected results and their start addresses.
Selection of the application blocks (FO)
Fig. 6–53: Configuration of the results output via field bus in the communication unit: selection of the application blocks for results
output
When an application block is selected, the memory area for the results output is automatically reserved
in the interface module. Here, the information on the maximum channels used in a tightening application
started in this application block is taken into consideration. If a tightening application containing fewer
channels is started in this application block, only the data in the memory area for the participating
channels will be valid.