Bosch Rexroth IPC 40.2, Руководство по планированию проекта

Страница: 39 / 82

IPC 40.2 Connections
7-9
DOK-SUPPL*-IPC*40.2***-PR02-EN-P
Note: The connected mouse must be PS/2-compatible. Normally,
the BIOS reserves IRQ 12 for the PS/2 mouse. If there are
address conflicts, e. g., if IRQ 12 has already been occupied
by another PC extension card, you should change the IRQ of
this extension card to another IRQ, that is still free.
Note: If a keyboard with integrated mouse is connected to the
interface XKeby, no mouse may be connected to the mouse
interface. The mouse integrated in the keyboard is available.
PC Power Supply
This connection is used for device variants for 24 VDC. All internally
required voltages are generated with electrical isolation via a DC/DC
converter. The connection is designed as connector terminal MSTB 1.5,
4-pin. To this connector terminal, cables with a cross section of maximum
1.5 mm² can be connected.
X10
4
24V
24V
0V
0V
4
1 2 3
2
3
1
Pin
Assignment
+
_
x10.cdr
Fig. 7-10: Pin assignment of the 24 VDC connection X10
Parameters Value
Rated voltage U
N
24 VDC +20 %, -15 %
Residual ripple for U
N
See figure below
Noise and surge immunity U
max
= 35 V (for t < 100 ms)
Current consumption for U
N
Max. 4.8 A
Line-side fuse M6,3A (5x20) medium time-lag
Reverse voltage protection Via isolating diode The line-side fuse is
activated when polarity reversal occurs.
Fig. 7-11: Technical data of the 24 VDC connection
X10 – 24-VDC Power Supply