RE 95289-01-B/2021-10-12, Bosch Rexroth AG
Installation |
BODAS displays
31
/40
7.3.5 Electrically connecting the BODAS display
1.
Make sure that the connector of the display and the mating connector of the wire
harness match; the pin assignment can be found in the respective data sheet,
see Table 1 "Required and supplementary documentation" on page 5.
2.
Make sure that the mating connector of the wire harness is in de-energized
condition.
3.
Connect the mating connector of the wiring harness to the display connector
until it engages noticeably and observe the correct plug-in position.
