Bosch Security Systems | 2008-12
PRS-1AIP1 IP Audio Interface
| Installation and User Instructions | Configuration
en
| 11
3.2.1
Network
Unit name
Default: clear
Enter a name for the device. This name will be
displayed in the title of the web browser application
page.
IP address
Default: 0.0.0.0
You can also enter the 4 values of the announced IP
address, or ask you system administrator for a valid IP
address and enter it here. Or you can enter e.g.
192.168.0.12 for an internal LAN.
Subnet mask
Default: 0.0.0.0
You can also enter the 4 values of the desired static IP
address, or enter 255.255.255.0 for a C class network
(standard).
Default gateway
Default: 0.0.0.0 (no gateway)
You can also enter the 4 values of the desired Gateway
IP address, or 192.168.0.1 for a Gateway in a LAN.
Use SonicIP
Default: Yes
The device will announce its IP address over the Audio
Outputs 1 and 2. If you select NO, then the device will
not announce its IP address. This way start up is faster.
Submit / Cancel button
Submit saves the set values, restarts the device and
returns back to the last screen. Cancel restores the last
submitted values.
3.2.2
Streaming
Audio is transmitted using RTP over UDP. This
requires no special configuration other than defining the
UDP ports to be used for the communication.
UDP Receiver Port
Default: 3030
You can also select 0 if the port is disabled or enter a
different number for receiving an RTP/UDP stream,
between 0 (disabled) and 65535.
UDP Tx Source Port
Default: 0
This setting is only used with a custom software
application. The default number 0 causes a random port
to be used.
You can also enter a specific source port number when
sending an RTP/UDP stream. Enter a value between 0
and 65535.
Back channel
Default: ON
The Backward Signal Data (Back) channel may be
turned ON or OFF. Set to ON if audio or control data
should be send back to the transmitter device.
Submit / Cancel button
Submit saves the set values, restarts the device and
returns back to the last screen. Cancel restores the last
submitted values.
Note
T
he Gateway has to be set only when
connecting to other devices over a WAN
through a router.
l
figure 3.3: Streaming screen (default UDP settings)
