English |
19
Measuring process
When switching on for the first time, the measuring tool will be in the length measure-
ment function. When switching on every subsequent time, the measuring tool will be in
the measuring function that was last used. For a different measuring function, press the
(2)
[
Func
] button. Use the
(6)
[
+
] button or the
(3)
[
–
] button to select the required
measuring function Measuring Functions. Activate the measuring function with the
(2)
[
Func
] button or with the measuring button
(5)
[ ].
Apply the measuring tool to the point at which you want to start the measurement (e.g.
wall).
Note:
If the measuring tool has been switched on using the on/off/back button
(8)
[ ],
briefly press the measuring button
(5)
[ ] to switch the laser on.
To initiate the measurement, briefly press the measuring button
(5)
[ ]. The laser beam
will then switch off. For a further measurement, repeat this process.
u
Do not direct the laser beam at persons or animals and do not stare into the laser
beam yourself (even from a distance).
Note:
The measured value typically appears within half a second, and no later than ap-
proximately four seconds. The duration of the measurement depends on the distance,
the lighting conditions and the reflective properties of the target surface. Upon comple-
tion of the measurement, the laser beam will automatically switch off.
Selecting the reference level (see figure A)
You can choose between three different reference levels for the measurement:
– The rear edge of the measuring tool (e.g. when placing against walls)
– The front edge of the measuring tool (e.g. when measuring from a table edge)
– The centre of the thread
(14)
(e.g. for tripod measurements)
To select the reference level, press the
(7)
[ ] button. Then select the “Reference level”
setting with the measuring button
(5)
[ ] or the
(2)
[
Func
] button. Then use the
(6)
[
+
]
button or the
(3)
[
–
] button to select the required reference level. Every time the meas-
uring tool is switched on, the last selected reference level is preset.
“Settings” menu (see figure B)
Press the
(7)
[ ] button to access the “Settings” menu
(i)
.
Use the
(6)
[
+
] button or the
(3)
[
–
] button to select the required setting and confirm
this by pressing the measuring button
(5)
[ ] or the
(2)
[
Func
] button.
Bosch Power Tools
1 609 92A 62A | (21.12.2020)
Содержание Professional GLM 50-23 G
