Bosch POF 1200 AE, Оригинальное руководство пользователя

Страница: 21 / 146

English | 21
Bosch Power Tools 1 609 929 S76 | (21.7.09)
f
Do not use blunt or damaged router bits.
Blunt or damaged router bits cause in-
creased friction, can become jammed and
lead to imbalance.
f When working with the machine, always
hold it firmly with both hands and provide
for a secure stance.
The power tool is guided
more secure with both hands.
f
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
f Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
f
Always wait until the machine has come to
a complete stop before placing it down.
The
tool insert can jam and lead to loss of control
over the power tool.
f Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working.
Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only : Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only : Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions.
Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Intended Use
The machine is intended for routing grooves, edg-
es, profiles and elongated holes as well as for
copy routing in wood, plastic and light building
materials, while resting firmly on the workpiece.
With reduced speed and with appropriate rout-
ing bits, non-ferrous alloys can also be machined.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-off button for On/Off switch
2 Right handle
3 Spindle lock button
4 Wing bolt for guide rods of parallel guide
(2x)*
5 Chip shield
6 Base plate
7 Guide plate
8 Seat for parallel guide rods
9 Step buffer
10 Dust boot
11 Wing bolt for depth stop adjustment
12 Slide with index mark
13 Depth stop
14 Scale for depth-of-cut
15 Left handle
16 Clamping lever for locking of routing depth
17 Scale for depth-of-cut fine adjustment
(POF 1400 ACE)
18 Adjustment knob for depth-of-cut fine
adjustment (POF 1400 ACE)
19 Mark for zeroing
20 Release lever for guide bushing
21 Router bit*
22 On/Off switch
23 Thumbwheel for speed preselection
24 Adjusting screws for step buffer
(POF 1200 AE)
25 Tightening nut with collet
26 Open-end spanner, size 19 mm*
27 Extraction hose (Ø 35 mm)*
OBJ_BUCH-323-003.book Page 21 Tuesday, July 21, 2009 12:51 PM