English |
15
Bosch Power Tools
1 609 929 X24 | (18.8.10)
– Always use dust extraction.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your country
for the materials to be worked.
The dust/chip extraction can be blocked by
dust, chips or workpiece fragments.
– Switch the machine off and pull the mains
plug from the socket outlet.
– Wait until the saw blade has come to a com-
plete stop.
– Determine the cause of the blockage and cor-
rect it.
Integrated Dust Extraction (see figure B)
– Press the clip of the dust bag
1
together and
slide the dust bag over the saw dust ejector
26
. The clip must engage into the groove of
the saw dust ejector.
During sawing, the dust bag must never come in-
to contact with the movable machine parts.
Always empty the dust bag in good time.
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 35 mm) can also be connected to the dust
ejector
26
.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool (see figures C1
–
C4)
f
Before any work on the machine itself, pull
the mains plug.
f
When mounting the saw blade, wear protec-
tive gloves.
Danger of injury when touching
the saw blade.
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
Use only saw blades recommended by the tool
manufacturer, and suitable for sawing the mate-
rials to be cut.
Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Push the locking lever
4
and swing the re-
tracting blade guard
6
to the rear to the stop.
Hold the retracting blade guard in this posi-
tion.
– Loosen screw
37
with a Phillips screwdriver.
– Pull the retracting blade guard
6
together
with the cover
38
upward, until hexagon bolt
40
is easily accessible.
– Guide the retracting blade guard
6
down
again, until it is held by the upper teeth of the
saw blade
39
.
– Turn hexagon bolt
40
with the provided ring
spanner
16
and at the same time press the
spindle lock
35
until it engages.
– Keep the spindle lock
35
pressed and un-
screw hexagon bolt
40
in clockwise direction
(left-hand thread!)
.
– Remove the clamping flange
41
.
– Lift the retracting blade guard
6
and remove
the saw blade
39
.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Lift the retracting blade guard
6
and position
the new saw blade onto the interior clamping
flange
42
.
f
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Mount clamping flange
41
and hexagon bolt
40
.
– Guide the retracting blade guard
6
down
again, until it is held by the upper teeth of the
saw blade
39
.
OBJ_BUCH-1304-001.book Page 15 Wednesday, August 18, 2010 10:12 AM
