English |
17
Bosch Power Tools
1 609 929 X24 | (18.8.10)
Adjusting the Cutting Angle
f
When adjusting the cutting angle, never ac-
tuate the On/Off switch 24.
Danger of injury
if the machine should accidentally start.
Adjusting Horizontal Mitre Angles
(see figure H)
The horizontal mitre angle can be set in the
range from 45° (left side) to 45° (right side).
– Loosen the locking knob
10
in case it is tight-
ened.
– Turn the saw table
7
left or right by the lock-
ing knob until the angle indicator
11
indi-
cates the requested mitre angle.
– Tighten the locking knob
10
again.
For quick and precise setting of often used mi-
tre angles,
the saw table
7
engages at the de-
tents of the following standard angles:
–45°/ –30°/ –22.5°/ –15°/
0°/ 15°/ 22.5°/ 30°/ 45°
Adjusting Vertical Bevel Angles
(see figure I)
The vertical bevel angle can be adjusted in a
range from 45° (leftward) to 45° (rightward).
– Loosen locking screw
28
and completely pull
out the fence extension
27
.
– Loosen the clamping lever
30
.
– Tilt the tool arm by the handle
3
until the an-
gle indicator
20
indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping lever
30
.
Note:
Clamping lever
30
is indexed (adjustable),
allowing it to be set to an ergonomically favour-
able and space-saving position.
With the clamping lever tightened, pull its lever
away from the machine, turn it to the desired
position and allow it to engage again.
For quick and precise setting of often used mi-
tre angles,
the saw table
7
engages at the de-
tents of the following standard angles:
0°/ ±15°/ ±30°/ ±45°
Starting Operation
f
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On (see figure J)
– To
start
the machine, press the On/Off
switch
24
and keep it pressed.
Note:
For safety reasons, the On/Off switch
24
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can be guided down only after
pushing the locking lever
4
.
– For
sawing
, you must additionally press lever
4
in addition to actuating the On/Off switch
24
.
Switching Off
– To
switch off
the machine, release the
On/Off switch
24
.
Working Advice
General Sawing Instructions
f
For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, screw clamps or other ma-
chine parts. Remove possibly mounted aux-
iliary stops or adjust them accordingly.
f
Wenn slotting, ensure that the saw blade
doesn’t get jammed in the workpiece.
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The work-
piece must always have a straight edge to face
against the fence.
OBJ_BUCH-1304-001.book Page 17 Wednesday, August 18, 2010 10:12 AM
