Bosch MicroDome NDC-274-PT, Руководство по установке

Страница: 19 / 28

MicroDome Camera 200 Series Installation | en 19
Bosch Security Systems Installation Manual AR18-10-B012 | v1.55 | 2012.09
3.8 Resetting the camera
If the camera cannot be connected because the IP address has
changed, press and hold the reset button (7 seconds
approximately) to recall the factory default values. The factory
default IP address is 192.168.0.1
Figure 3.6 Reset button
3.9 Closing the unit
When the camera position is set and all adjustments have been
made, close the unit.
1. Remove the monitor cable from the jack socket.
2. If necessary, clean the inner surface of the dome with a
soft cloth.
3. Position the dome on the base by aligning the two screw
holders with fins with the openings beside the screw
sockets and slot it home.
4. Use the supplied special screwdriver bit to tighten the
three tamper-resistant screws.