- 3 -
PRODUCT INSTRUCTIONS
MODELS LTC9348/00
General Instructions:
1. Carefully remove all equipment from the box.
2. Cut a 11.125" hole into the ceiling in the desired spot.
3. Remove the desired conduit knock-out from the top of
the MR7 housing.
4. Remove the trim ring and dome by pulling on the outside
of the trim ring. The ring and dome, are connected by
three flat springs, which press against the side of the
housing and lock into (3) cutouts.
5. With the support arms (3) rotated to the inside, slide the
housing into the pre-cut hole (See Figure 1).
6. With the bottom flange pressed up against the ceiling,
rotate the support arms to the outside, the arms will fall to
the back side of the ceiling. Tighten the (3) support arm
screws.
7. If the housings is going into a ceiling where the support
arms will not work, the housing can be secured to the
ceiling by running bolts through the bottom flange into
the solid ceiling.
8. Connect the support wires to the top of the housing
through the two provided slots.
9. Run electrical cable into the housing through the conduit
knock-out.
10.
USE ONLYWITH CLASS 2 POWER SUPPLY.
10. The camera can be mount on either side of the tilt part of
the camera bracket (Figure 4).
11. Complete all electrical connections, and adjust the
camera to the proper angle.
12. Reattach dome and faceplate by pressing in and sliding
the three flat springs into the housing, make sure the
springs are aligned with the three spring slots. You will feel
all three springs snap into place when the dome is
correctly secured into place.
13. Adjust the drop-in-liner so that the viewing slot is in the
proper position.
Figure 1
Mounting holes
Support arm screws
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
10.0"
7.0"
12.0"
7.0"
ceiling
cross section
tinted or clear
dome with liner
support arms
Support arms
rotated out
