B
C
If in doubt, look it up
83
Menu items on the display
"
You can set the baud rate of your telephone for data transmission here.
The values 1200, 2400, 4800 and 9600 are available.
The menu point only appears if you have set the AEI operating mode to
“AT command”.
You can set the data bits of your telephone for data transmission here. The
settings “7 bit” and “8 bit” are available.
The menu point only appears if you have set the AEI operating mode to
“AT command”.
You can set the parity of your telephone for data transmission here. The
settings, “none”“even” and “uneven” are available.
The menu point only appears if you have set the AEI operating mode to
“AT command”.
Your telephone has been factory-set so that while connected all key de-
pressions can be sent as tones. You can also turn off this function and
initiate the postdialing manually while connected.
(only TH and TM) With this you can additionally adjust the setting for
handsfree talking to room conditions. Your telephone must be designed
with the comfort handsfree equipment for this. If necessary, consult your
BOSCH TELECOM Service.
If the called party is busy, your phone will send a signal as soon as the line
is free again.
Your phone and the phone of the previously busy subscriber will ring and
you can set up the call.
However, this is only possible for calls within your system.
AT baud rate
AT data bits
AT parity
Autom. post dialing/DTMF
(
p. 58)
Balancing handsfree calling
-
〈→
p. LEERER MERKER)
Call back
