Bosch HSG732155M, Инструкция по установке и эксплуатации

Страница: 20 / 72

20
Connection to nominal voltage 220-240 V. Connect the wires of
the mains power cord according to the colour coding: green/
yellow = PE conductor
<
, blue = (zero) neutral conductor,
brown = phase (external conductor).
GB, IE, NZ, IL, DK and AU
Fixed connection only.
Power cable with a plug with earthing contact
The appliance can also be connected using the enclosed plug
with earthing contact to a properly installed earthed socket. The
socket must be accessible after installation. If this is not the
case, an all-pole isolating switch with a contact gap of at least
3 mm must be included in the installation.
Gas connection
The appliance must be connected in accordance with the
currently applicable regulations. Before installing the appliance,
check if the local conditions (type of gas and pressure) are
compatible with the appliance settings. The conditions for
setting the appliance can be found on the rating plate.
Connection to the gas lines and seal fitting must be carried out
professionally according to the currently applicable standards.
Gas connection on the appliance
Model HSG738155M and HSG736155M:
The gas connection (ISO 228 G1/2) is located at the rear left of
the appliance. The following connections are provided with the
appliance:
Model HSG732155M:
The gas connection (ISO 228 G1/2) is located at the rear left of
the appliance. The following connections are provided with the
appliance:
Default setting of the burners
The burners are set up for G30 liquefied gas (29 mbar) on
delivery. A nozzle set for G20 natural gas (20 mbar) is supplied
with the appliance.
Connecting to natural gas
Model HSG738155M and HSG736155M:
Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
1. Screw the bend (3) and the seal (2) to the gas connection
(1).
2. Hold the bend with a spanner and screw the adapter piece
(5) and the seal (4) to the bend (3).
3. Hold the adapter piece (5) with a spanner and screw it to a
fixed connecting line (6) or a flexible gas connecting hose.
Only use approved sealing compound to seal the thread.
Model HSG732155M:
Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
1. Screw the adapter piece (3) and the seal (2) to the gas
connection (1).
2. Hold the adapter piece (3) with a spanner and screw it to a
fixed connecting line (4) or a flexible gas connecting hose.
Only use approved sealing compound to seal the thread.
Bend with external thread EN ISO 228 G1/2 -
EN ISO 228 G1/2 (with flat seal)
Adapter piece EN ISO 228 G1/2 - EN 10226 R1/2
(with flat seal)
Hose connection EN ISO 228 G1/2 - LPG (with flat
seal)
Adapter piece EN ISO 228 G1/2 - EN 10226 R1/2
(with flat seal)
Hose connection EN ISO 228 G1/2 - LPG (with flat
seal)