Bosch HKS79R250A, Инструкция по эксплуатации

Страница: 28 / 48

en
Appliance door
28
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the oven door.
When removing the inner panels, pay attention to the
sequence in which the panels are removed. In order to
reassemble the panels in the correct sequence, use the
numbers that appear on each panel.
Removal
1.
Detach the oven door and lay it on a cloth with the
handle facing down.
2.
Unscrew the cover at the top of the oven door. To do
this, unscrew the left and right screws (fig. A).
3.
Lift the top panel up and pull it out and remove the
two small seals (fig. B).
4.
Unscrew the retaining clips on the right and left. Lift
the panel and remove the clips from the panel
(fig. C).
5.
Remove the seal from the bottom of the panel (fig.
D). Pull the seal and remove it up and out. Pull out
the panel.
6.
Pull the lower panel at an angle, upwards and out.
7.
Do NOT unscrew the left and right-hand screws from
the sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "right
above" is upside down at the bottom left of both panels.
1.
Insert the lower panel at an angle towards the back
(fig. A).
2.
Slide in the middle panel (fig. B).
3.
Stick the retaining clips onto the right and left-hand
side of the panel, aligning them so that the retaining
carriers are over the screw holes, and then screw
into place (fig. C).
4.
Hook the seal in to the bottom of the panel again
(fig. D).
5.
Insert the uppermost panel at an angle to the back
into the brackets. Take care not to push the seal to
the back (fig. E).
6.
Insert the two small seals on the left and right of the
panel again (fig. F).
7.
Put the cover back in place and screw it on.
8.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
% $
' &
(
% $
' &
) (