Bosch HGN21F350I, Инструкция по эксплуатации

Страница: 11 / 28

11
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven
(a).
Note:
The notch below the hinges must engage into the
frame of the oven
(b)
.
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales service.
Removing and inserting the hook-in racks
You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
1.
Grip the front of the hook-in rack and pull it to the middle of
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
2.
Fold out the hook-in rack further and pull it from the rear
holes of the side panel.
3.
Hold the catalytic cooking compartment panel in place.
4.
Remove the hook-in rack from the cooking compartment.
Inserting the hook-in rack
1.
Hold the catalytic cooking compartment panel in place.
2.
Insert the hooks of the hook-in rack into the rear holes in the
side panel.
3.
Press the front hook of the hook-in rack into the hole.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service, as you may be able to
remedy the fault yourself.
:
Risk of injury!
Incorrect repairs are dangerous. Repairs may only be carried
out, and damaged power and gas lines replaced, by an after-
sales engineer trained by us. If the appliance is faulty, unplug
the mains plug or switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales service.
--------
Replacing the oven light bulb
If the oven light bulb fails, it must be replaced. Replacement
heat-resistant bulbs can be obtained from the after-sales
service or from specialist retailers. Please specify the E number
and FD number of your appliance. Do not use any other type of
bulb.
:
Risk of electric shock!
When replacing the cooking compartment bulb, the bulb socket
contacts are live. Before replacing the bulb, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box.
1.
Allow the cooking compartment to cool down.
2.
Open the appliance door.
3.
Place a tea towel in the cooking compartment to prevent
damage.
4.
Remove the hook-in racks.
5.
Remove the glass cover. To do this, open the glass cover at
the front with your hand. Should you experience difficulties
removing the glass cover, use a spoon to help.
E D
D
E
Malfunction Possible cause Solution
The appliance
does not work
Power cut Check whether other
kitchen appliances are
working
Faulty circuit
breaker
Check in the fuse box to
make sure that the circuit-
breaker for the appliance is
OK
The oven light-
ing has failed.
Oven light is
faulty
Replace the oven light.
(See section "Replacing
oven light")
The flame
(oven) does not
burn through all
outlet openings.
Normal build-up
of dirt
The burner must be profes-
sionally cleaned.
The door panel
steams up
when the oven
heats up.
Normal occur-
rence; caused
by the differ-
ence in tempera-
ture
Not possible; this has no
effect on oven performance.