Bosch HGA233120I, Инструкция по эксплуатации

Страница: 15 / 28

15
Setting the oven
Here you can find out how to set the oven.
This is how you adjust the lower gas burner in
the oven
When the lower gas burner is lit, you can bake on a baking
sheet with the oven door closed.
Example in the picture: Baking at 170 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
to the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
170 °C.
4.
While holding the switch for the lower gas burner depressed,
press the ignition button
8
.
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety ignition, press
and hold the lower gas burner on the oven for 10 seconds.
The safety ignition is activated. If the gas flame goes out, the
gas supply is automatically interrupted by the safety ignition
system.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Preheat the empty oven for approximately 15 minutes before
baking.
9.
When the dish has finished cooking, turn off the switch for the
lower gas burner.
You can change the temperature at any time.
:
Caution:!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Procedure for setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn on the main gas supply to the appliance. Connect the
plug to the socket.
3.
Insert the protecting plate into the groove under the control
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
4.
Close the oven door so that it is in contact with the protecting
plate.
5.
Press the function selector and turn it clockwise to the grill
setting
(
.
6.
Keep the function selector pressed in and simultaneously
press the ignition button
8
.
7.
The gas leaving the gas grill is ignited using the ignition
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
The ignition safety system is activated. If the gas flame goes
out, the gas supply is automatically interrupted by the ignition
safety system.
8.
Check whether the flame is lit. If the flame is not lit, repeat the
process from step 5.
9.
Once the meal is cooked, switch off the function selector.
Once the oven has cooled down, remove the protecting
plate.
Pans should be placed on the
hob carefully.
Do not strike the hob and do
not place excessive weight on
it.
Never use two burners or heat
sources to heat one single
pan.
Do not use grill pans,
earthenware casserole dishes,
etc. for a long period of time
on maximum power.