Bosch HGA233120I, Инструкция по эксплуатации

Страница: 13 / 28

13
Procedure for setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn on the main gas supply to the appliance. Connect the
plug to the socket.
3.
Insert the protecting plate into the groove under the control
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
4.
Close the oven door so that it is in contact with the protecting
plate.
5.
Press the function selector and turn it clockwise to the grill
setting ( .
6.
Keep the function selector pressed in and simultaneously
press the ignition button 8 .
7.
The gas leaving the gas grill is ignited using the ignition
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
8.
Check whether the flame is lit. If the flame is not lit, repeat the
process from step 5.
9.
Switch off the function selector after 30 minutes. Once the
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Making settings on the hob
Your hob is equipped with four gas burners. The following
information explains how to light the gas burners and set the
size of flame.
Advance cleaning of burner cup and cap
Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.
Igniting the gas burners
Always position the burner cap exactly onto the burner cup. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
1.
Open the upper cooker cover. The upper cover must remain
open whilst the cooker is in operation.
2.
Turn the control for the required hotplate anti-clockwise to the
symbol with the large flame — .
3.
With the hotplate control pressed in, press the ignition button.
Gas begins to flow out and the gas burner ignites.
4.
Press and hold the hotplate control for 1-3 seconds. This
activates the safety pilot. If the gas flame goes out, the gas
supply is automatically cut off by the safety pilot.
5.
Set the required flame size. Between the Off
û
setting and the
—
setting, the flame is not stable. Therefore, always choose a
setting between the large flame
—
and small flame
˜
.
6.
If the flame goes out again, repeat the process from step 2.
7.
To finish cooking, turn the hotplate control clockwise to the
Off
û
position.
The hotplate control should not be turned to the ignition
position for longer than 15 seconds. If the burner does not light
within 15 seconds, wait at least one minute. Then repeat the
ignition process.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.