Bosch HB.64B Series, Инструкция по эксплуатации

Страница: 11 / 24

11
Self-cleaning has ended.
The display panel will show
‹‹
:
‹‹
. The oven will stop heating.
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H symbol on the display panel turns off.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H
symbol on the display panel turns off.
Delaying the end time
The oven allows you to programme the self-cleaning end time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in section 1 and 2. Before starting the
self-cleaning, press the 0 sensor three times and delay the
end time with the @ or A sensors.
The oven is set to standby. The display panel will show the
cleaning level and the y symbol. When self-cleaning starts, the
cleaning level and the
x
symbol are shown. The
y
symbol
switches off.
Viewing the time settings
To view the duration of the cleaning level or the end time of the
self-cleaning press the 0 sensor repeatedly until the required
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
■
Different colours may be seen in your front panel due to the
various materials used in its manufacture, such as glass,
plastic and metal.
■
Dark patches in the door's glass panel may seem to be dirt
but they are in fact reflections from the oven light.
■
Enamel burns at very high temperatures. This may cause
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
■
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges
■
high-pressure or steam cleaners.
Wash new dishcloths thoroughly before use.
Light
The oven light can be turned on manually to facilitate cleaning.
Connecting the oven bulb
Turn the function control knob to the
^
position.
The light will come on.
Turning the oven light off
Turn the function control knob to the Û position.
Zone Cleaning products
Front panel Hot water and a little soap:
Clean with a dishcloth and dry with a soft
cloth. Do not use a glass cleaning product or
a glass scraper.
Stainless
steel
Hot water and a little soap:
Clean with a dishcloth and dry with a soft
cloth. Immediately remove any water marks,
grease, cornflower or egg white stains since
corrosion could occur underneath these
marks or stains.
Special products for the care of stainless
steel which are suitable for hot surfaces may
be obtained from Technical Assistance Serv-
ice centres and specialist retail outlets. Use a
very fine soft cloth to apply the cleaning prod-
uct.
Glass panel Glass cleaning products:
Clean with a soft cloth. Do not use a glass
scraper.
Display Glass cleaning products:
Clean with a soft cloth. Do not use alcohol,
vinegar or other abrasive or acidic cleaning
products.
Glass panels
on oven door
Glass cleaning products:
Clean with a soft cloth. Do not use a glass
scraper.
Door covering Only use products specially for cleaning stain-
less steel (these can be obtained from the
Technical Assistance Service or from special-
ist shops). Follow the manufacturer's instruc-
tions.
Inside the oven Hot water with a little soap or water and vine-
gar:
Clean with a dishcloth.
If very dirty, use a stainless steel scourer or
special oven cleaning products. These must
only be used when the oven interior is cold.
Whenever possible, use the self-cleaning
function. See the chapter on the Self-cleaning
function.
Glass cover for
the oven light
Hot water and a little soap:
Clean with a dishcloth.
Guides or rails Hot water and a little soap:
Soak and clean using a dishcloth or brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do not
leave this to soak or wash in a dishwasher.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or brush.
Zone Cleaning products