Bosch GWS Professional 10-125, Оригинальное руководство пользователя

Страница: 21 / 294

20 | English
u
X-LOCK application tools do not need additional clamping
flanges or support flanges.
u
Make sure that the application tool and the holder are not
deformed and are free from dirt and particles.
Pay attention to the dimensions of the abrasive tools.
Make sure that
both X-LOCK catches are open (see figure
below) before fitting the X-LOCK application tool.
If necessary, clean the area between the two X-LOCK
catches.
Fitting the abrasive tool
➊ Place the grinding/cutting/flap disc in a central position
on the X-LOCK holder, parallel to the bearing surface
and with the right side facing up.
➋ Push the disc into the holder.
➌
The disc audibly clicks into place. Do not actuate the
lever
(3) when doing so.
(3)
u
After fitting, check that the edge of the abrasive tool
(
➍ ) is fitted correctly, i.e. is no higher than the refer-
ence surface ( ➎ ). If the edge is higher than the refer-
ence surface, either the holder must be cleaned or the
abrasive tool must not be used.
Before removing the grinding/cutting/flap disc: Make
sure that the power tool has come to a complete stop.
Removing the abrasive tool
➊ Open the lever (3) .
➋ The grinding/cutting/flap disc will be released.
➌ The grinding/cutting/flap disc can be removed.
(3)
(3)
Cup brushes/disc brushes and fibre discs
u
Always fit the hand guard (13) when working with the
cup brush/disc brush or fibre disc.
See the graphics page for fitting instructions.
To remove an application tool, open the lever
(3) and re-
move the application tool.
Approved abrasive tools
You can use all the abrasive tools mentioned in these operat-
ing instructions.
The permissible speed [min
-1
] or the circumferential speed
[m/s] of the abrasive tools used must at least match the val-
ues given in the table.
It is therefore important to observe the permissible
rota-
tional/circumferential speed on the label of the abrasive
tool.
max. [mm] [mm]
D b d [min
-1
] [m/s]
125 7 22.2 11,000 80
125 – – 11,000 80
75 30 – 11,000 45
82 – – 11,000 80
Rotating the machine head
u
Pull the plug out of the socket before carrying out any
work on the power tool.
The machine head can be
rotated in 90° increments.
In this way, the on/off
switch can be brought into
a more favourable handling
position for particular ap-
plications, e.g. for left-
handed tool users.
1 609 92A 5WL | (21.08.2020) Bosch Power Tools
Автотовары
«130»
130.com.ua