English |
13
Bosch Power Tools
1 609 929 S87 | (19.10.09)
Mounting the Grinding Tools
f
Before any work on the machine itself, pull
the mains plug.
f
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Clean the grinder spindle
6
and all parts to be
mounted.
For clamping and loosening the grinding tools,
lock the grinder spindle with the spindle lock
button
2
.
f
Actuate the spindle lock button only when
the grinder spindle is at a standstill.
Other-
wise, the machine may become damaged.
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding
tools. The mounting hole diameter must fit the
mounting flange without play. Do not use reduc-
ers or adapters.
When using diamond cutting discs, pay atten-
tion that the direction-of-rotation arrow on the
diamond cutting disc and the direction of rota-
tion of the machine (see direction-of-rotation ar-
row on the machine head) agree.
See graphics page for the mounting sequence.
To fasten the grinding/cutting disc, screw on
the clamping nut
10
and tighten with the two-
pin spanner; see Section “Quick-clamping Nut ”.
f
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn free-
ly. Make sure that the grinding tool does
not graze against the protection guard or
other parts.
An O-ring (plastic part) is in-
serted in the mounting flange
8
around the centring collar.
If
the O-ring is missing or is
damaged,
it must in all cases
be replaced (article number
1 600 210 039) before the
mounting flange
8
is mounted.
Flap Disc
f
For operations with the flap disc, always
mount the hand guard 15.
Rubber Sanding Plate
f
For operations with the rubber sanding
plate 16, always mount the hand guard 15.
See graphics page for the mounting sequence.
Screw on the round nut
18
and tighten with the
two-pin spanner.
Cup Brush/Disc Brush
f
For operations with the cup brush/wheel
brush, always mount the hand guard 15.
See graphics page for the mounting sequence.
The cup brush/disc brush must be able to be
screwed onto the grinder spindle until it rests
firmly against the grinder spindle flange at the
end of the grinder spindle threads. Tighten the
cup brush/disc brush with an open-end span-
ner.
Quick-clamping Nut
For convenient changing of grinding tools with-
out the use of additional tools, you can use the
quick-clamping nut
11
instead of the clamping
nut
10
.
f
The quick-clamping nut 11 may be used only
for grinding or cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 11.
When screwing on, pay attention that the side
of the quick-clamping nut 11 with printing
does not face the grinding disc; the arrow must
point to the index mark 23.
Lock the grinder spin-
dle with the spindle
lock button
2
. To tight-
en the quick-clamping
nut, firmly turn the
grinding disc in clock-
wise direction.
23
OBJ_BUCH-194-004.book Page 13 Monday, October 19, 2009 9:00 AM
