Step 4. Attach Linkage
Bar/Wheel Assemblies
1.
Locate the right linkage bar
D
/wheel
assembly
G
and position on right side
of upper/lower cross bar assembly
A
as shown in figure 4.
Note:
Wheel
should face outward from stand.
2.
Place one (1) flat washer
L
onto one
(1) bolt
J
and insert through right
wheel assembly
G
.
3.
Place another (1) flat washer
L
on
bolt between wheel assembly
G
and
upper/lower cross bar assembly
A
.
4.
Insert bolt through upper/lower cross
bar assembly
A
, place one (1) flat
washer
L
. Using two 13mm wrenches
tighten with one (1) lock nut
M
until
all the parts can not move freely.
Then loosen the nut by 1/8 to 1/4
turn.
Note:
Do not over-tighten lock
nut - these parts need to freely rotate
for stand to operate properly.
5.
Repeat procedure on left side.
Step 5. Attach Kick Bar
1.
Locate the kick bar
C
and position it
between the left and right wheel
assemblies
H
and
G
as shown in
figure 5.
2.
Place one (1) star washer
P
onto one
(1) hex head bolt
O
. Insert bolt
through the wheel assembly and
thread it into the kick bar
C
and,
using 13mm wrench, tighten down to
the point when the star washer
P
cannot move freely. Then tighten
securely by turning bolt an additional
3/4 to 1 full turn.
3.
Repeat this procedure on opposite
side.
Step 6. Attach Top Tube Bar
1.
Locate the top tube bar
F
. Position
holes in end of top tube bar
F
with
holes in upper cross bar
A
as shown
in figure 6. Make sure the plastic
bumpers
FF
are pointing down (Fig.
6a)!
2.
Place one (1) flat washer
L
onto one
(1) hex head bolt
J
.
3.
Insert bolt
J
through top tube bar
F
and place small spacer
R
on bolt
between top tube bar
F
and upper
cross bar
A
.
4.
Insert bolt through upper cross bar
A
,
place one (1) flat washer
L
. Using
two 13mm wrenches tighten with
one (1) lock nut
M
until all the parts
can not move freely. Then loosen the
nut by 1/8 to 1/4 turn.
Note:
Do not
over-tighten lock nut - these parts
C
C
G
H
P
G
O
-6-
M
L
L
L
J
A
G
G
A
D
Assembly
Fig. 4
Fig. 5
2610047964.qxp_GTA47W 11/15/19 9:11 AM Page 6
