1 609 929 M40 | (23.10.07)
Bosch Power Tools
10
| English
Assembly
Auxiliary Handle (see figure A)
f
Operate your power tool only with the auxil-
iary handle 12.
The auxiliary handle
12
can be set to any position
for a secure and low-fatigue working positure.
Turn the bottom part of the auxiliary handle
12
in
counterclockwise direction and swivel the auxil-
iary handle
12
to the desired position. Then re-
tighten the bottom part of the auxiliary handle
12
by turning in clockwise direction.
Adjusting the Drilling Depth (see figure A)
The required drilling depth
X
can be set with the
depth stop
13
.
Press the button for the depth stop adjustment
11
and insert the depth stop into the auxiliary
handle
12
.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth
X
.
The knurled surface of the depth stop
13
must
face upward.
Changing the Tool
f
Before any work on the power tool itself,
pull the mains plug.
Keyless Chuck (see figure B)
The drill spindle is locked when the On/Off
switch
7
is not pressed. This makes quick, conve-
nient and easy changing of the tool in the drill
chuck possible.
Open the keyless chuck
1
by turning in rotation
direction
n
until the tool can be inserted. Insert
the tool.
Firmly tighten the collar of the keyless chuck
1
by
hand in rotation direction
o
until the locking ac-
tion (“click”) is no longer heard. This automati-
cally locks the chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Key-type Drill Chuck (see figure C)
f
Wear protective gloves when changing the
tool.
The drill chuck can become very hot dur-
ing longer work periods.
Open the key-type drill chuck
15
by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key
14
into the corresponding
holes of the key-type drill chuck
15
and clamp the
tool uniformly.
Screwdriver Tools (see figure D)
When working with screwdriver bits
16
, a univer-
sal bit holder
17
should always be used. Use only
screwdriver bits that fit the screw head.
For driving screws, always position the “Drill-
ing/Impact Drilling” selector switch
2
to the
“Drilling” symbol.
Replacing the Drill Chuck
f
Before any work on the power tool itself,
pull the mains plug.
f
For power tools without spindle lock, the
drill chuck must be replaced by an autho-
rized after-sales service agent for Bosch
power tools.
Removing the Drill Chuck (see figure E)
Disassemble the auxiliary handle and set the gear
selector
10
to the center position between the
1st and 2nd gear.
Insert a steel pin with a diameter of
Ø
4 mm and
approx. 50 mm of length into the drill hole on the
spindle neck in order to lock the drill spindle.
Clamp the short end of a hex key
18
into the key-
less chuck
1
.
Place the machine on a stable surface (e. g. a
workbench). Hold the machine firmly and loosen
the keyless chuck
1
by turning the hex key
18
in
rotation direction
n
. Loosen a tight-seated key-
less chuck by giving the long end of the hex key
18
a light blow. Remove the hex key from the key-
less chuck and completely unscrew the keyless
chuck.
OBJ_BUCH-129-002.book Page 10 Tuesday, October 23, 2007 2:57 PM
