Switch Lock
Your tool is equipped with a switch lock
located above the trigger. This lever is
designed for locking the trigger in the
" O F F " p o s i t i o n t o h e l p p r e v e n t
accidental starts and accidental battery
discharge.
To lock the trigger, press the lock (
)
side of the switch lock until it clicks
(Fig. 5).
A l w a y s m o v e t h e
s w i t c h l o c k t o t h e
locked position whenever the tool is
not being used.
To unlock trigger, press the unlock (
)
side of the switch lock until it clicks
(Fig. 6).
-10-
Protection Against Deep
Discharging
The lithium ion battery is protected
a g a i n s t d e e p d i s c h a r g i n g b y t h e
“ E l e c t r o n i c C e l l P r o t e c t i o n ( E C P ) ” .
When the battery is empty, the tool is
switched off by means of a protective
circuit.
Do not continue to
p r e s s t h e t r i g g e r
s w i t c h a f t e r t h e t o o l h a s b e e n
automatically switched off.
The battery
can be damaged.
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable
speed controlled trigger switch. The
tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The
b l a d e p l u n g e r s t r o k e r a t e c a n b e
adjusted from the minimum to maximum
nameplate stroke rate by the pressure
you apply to the trigger. Apply more
pressure to increase the speed and
release pressure to decrease speed.
The required stroke rate is dependent
o n t h e m a t e r i a l a n d t h e w o r k i n g
conditions and can be determined by a
practical trial.
R e d u c i n g
t h e
s t r o k e
r a t e
i s
r e c o m m e n d e d w h e n t h e s a w b l a d e
engages in the material as well as when
sawing plastic and aluminum.
Built-in Led Work Light
Your tool is equipped with an LED work
light that turns on automatically when the
trigger switch is activated. When the tool
is turned off, the light turns off (Fig. 1).
FIG. 5
VARIABLE SPEED
TRIGGER SWITCH
SWITCH
LOCK
FIG. 6
VARIABLE SPEED
TRIGGER SWITCH
SWITCH
LOCK
Operating Instructions
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories.
Such preventive safety measures
reduce the risk of starting the tool accidentally.
