Bosch GL-50, Инструкция по эксплуатации

Страница: 15 / 117

Downloaded from www.vandenborre.be
16
Figure
●
After use, place the crevice or upholstery nozzle back
into the accessories compartment in the appliance lid.
Turbo brush
If your appliance is equipped with a turbo brush, please
consult the accompanying instruction manual for in-
structions on its use and maintenance.
Figure
●
You can use the nozzle parking aid on the back of the
appliance if you wish to stop vacuuming for a short
time.
●
Once you have switched off the appliance, slide the
hook on the floor tool into the recess on the rear of
the appliance.
Figure
To overcome obstacles, e.g. steps, the appliance can
also be carried by the handle on the appliance body.
When the work is done
Figure
●
Pull out the mains plug.
●
Tug the power cord briefly and then let go (the power
cord retracts automatically).
Figure
●
To store or transport the appliance, you can use the
storage aid on the underside of the appliance.
●
Stand the appliance up on its end. Slide the catch on
the floor tool into the groove on the underside of the
appliance.
Changing the filter
!
Please note: Always switch off the appliance before
changing the filter.
Replacing the dust bag
Figure
a)
If the dust bag change indicator lights up red
continuously when the floor tool is lifted from the
floor and the highest power setting has been
selected, the dust bag must be changed, even though
it may not yet be full. Even if the dust bag is not full, it
may still need changing, due to the type of dust which
has been vacuumed.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
dust bag change indicator being triggered.
b) The handle can easily be detached from the hose to
remove blockages.
13
14
18*
17
16
15
Figure
Opening the lid
●
Open the lid by moving the locking lever in the
direction of the arrow.
Figure
a)
Seal the dust bag by pulling the sealing tab, and
remove the bag.
b)
Insert the new dust bag into the holder up to the
stop.
!
Caution: the lid will only close if a dust bag has
been inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by tapping out the dirt and rinsing.
Figure
●
Open the dust bag compartment lid.
Figure
●
Pull out the motor protection filter in the direction of
the arrow.
●
Clean the motor protection filter by tapping out the
dirt.
●
If it is very dirty, the motor protection filter should be
rinsed out.
The filter must then be left to dry for at least
24 hours.
●
After cleaning, insert the motor protection filter into
the appliance and close the dust bag compartment
lid.
Replacing the exhaust filter
Replacing the micro-hygiene filter
This should be replaced with every replacement filter
pack
Figure
●
Open the dust bag compartment lid.
Figure
●
Release the filter holder by turning the locking lever in
the direction of the arrow.
●
Remove the micro-hygiene filter. Insert the new micro-
hygiene filter into the appliance.
●
Insert the filter holder in the appliance and lock it in
place.
Replacing the Hepa filter
If your appliance is equipped with a Hepa filter, this
should be replaced once a year.
Figure
●
Open the dust bag compartment lid.
Figure
●
Unlock the Hepa filter by turning the locking lever in
the direction of the arrow and remove the filter from
the appliance.
●
Insert the new Hepa filter and lock it in place.
If you have vacuumed up fine dust particles, clean the
motor protection filter and, if necessary, replace the
micro-hygiene filter or Hepa filter.
19
23
19
20
19
22
19
21
en