-12-
Assembly
Changing the Chuck
Do not carry the tool
b y t h e c h u c k .
T o o l
may unexpectedly fall if the chuck is not
fully engaged.
T h i s t o o l c o m e s w i t h a r e p l a c e a b l e
c h u c k . T h i s a l l o w s f o r f a s t , e a s y
replacement of the SDS-plus chuck. It
also allows the use of a 3-jaw chuck
(sold separately), which converts the
tool for use with a variety of straight
shank bits for drilling and driving.
REMOVING THE SDS-PLUS® CHUCK
Grasp the locking ring
3
of the SDS-plus
quick change chuck and pull forcefully
in direction of arrow
A
while pulling
chuck
2
in direction of arrow
B
and
remove from tool (Fig. 6).
ATTACHING THE 3-JAW CHUCK
(Not included, available as accessory)
W h e n
t h e
3 - j a w
chuck is installed, the
tool must be used in DRILLING mode
o n l y .
U s i n g t h e t o o l i n H A M M E R I N G
mode can cause damage to the 3-jaw
chuck and may cause bits to become
loose and cause damage or injury.
Grasp the 3-jaw chuck
18
firmly with
your hand and push it onto the tool with
a twisting motion until you hear it lock
into place (Fig. 7).
Pull outward on the chuck to be certain
it is locked into the tool.
INSTALLING AND REMOVING
ACCESSORIES WHEN USING 3-JAW
CHUCK
Hold chuck collar
18b
with one hand
and rotate chuck sleeve
18a
in direction
of arrow
C
with the other hand until the
jaws are open (Fig. 9).
For small bits, open jaws enough to
insert the bit up to the flutes. For large
bits, insert the bit as far as it will go.
Insert bit, hold the chuck collar with one
h a n d a n d r o t a t e c h u c k s l e e v e i n
direction of arrow
A
with the other hand
u n t i l i t l a t c h e s . T h e n c l a m p t h e
accessory by continuing to turn the
chuck sleeve forcefully in direction of
arrow
A
until you hear a ratcheting
sound (Fig. 8).
2
3
A
B
Fig. 6
2
18
3
Fig. 7
18a
18b
A
B
18a
18b
C
D
Fig. 8
Fig. 9
