Installing SDS-plus®
Accessories
C l e a n t h e i n s e r t s h a n k e n d o f t h e
accessory to remove any debris, then
l i g h t l y g r e a s e w i t h a l i g h t o i l o r
lubricant.
Insert accessory into the tool holder
through the dust shield
1
, while twisting
and pushing inward until it sets into
place. Pull outward on the accessory to
be certain it is locked into the tool
holder (Fig. 3).
Note:
The high efficiency available from
t h e r o t a r y h a m m e r s c a n o n l y b e
o b t a i n e d i f s h a r p a n d u n d a m a g e d
accessories are used. The "cost" to
m a i n t a i n
s h a r p
a n d
u n d a m a g e d
accessories is more than offset by the
"time saved" in operating the tool with
sharp accessories.
Removing SDS-plus®
Accessories
Accessories may be
hot after use.
Avoid
c o n t a c t w i t h s k i n a n d u s e p r o p e r
protective gloves or cloth to remove.
To remove an accessory, pull accessory
locking sleeve
2
backward and pull bit
f o r w a r d . A l l a c c e s s o r i e s s h o u l d b e
wiped clean after removing (Fig. 4).
Auxiliary Handle
The tool must be used with the auxiliary
handle
14
, which can be swiveled 360˚.
To reposition and/or swivel the handle
14
, loosen the hand grip, move the
handle to the desired position along the
barrel and securely retighten the hand
grip (Fig. 5).
-11-
Assembly
1
2
1
2
Fig. 3
Fig. 4
B
C
A
14
Fig. 5
