Bosch GBH 36 V-LI Compact, Оригинальное руководство пользователя

Страница: 22 / 317

22 | English
1 619 929 797 | (3.2.09) Bosch Power Tools
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 09.10.2007
Assembly
Battery Charging
f
Use only the battery chargers listed on the
accessories page.
Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The Li-ion battery is protected against deep dis-
charging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Do not continue to press the
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
Removing the Battery
The battery 11 is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking button
12 unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
means of a spring.
To remove the battery 11 :
– Push the battery against the base of the pow-
er tool (1.) and at the same time press the
battery unlocking button
12 (2.).
– Pull the battery out of the power tool until a
red stripe becomes visible (3.).
– Press the battery unlocking button 12 again
and pull out the battery completely.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator
14 indicate the charge condition of
the battery 11 . For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
– Push button
15 to indicate the charge condi-
tion (also possible when the battery is re-
moved). The battery charge-control indicator
automatically goes out after approx.
5 seconds.
When no LED lights up after pushing button 15 ,
then the battery is defective and must be re-
placed.
Dr. Egbert Schneider
Senior Vice President
Engineering Dr. Eckerhard Strötgen
Head of Product
Certification
WARNING
LED Capacity
Continuous lighting 3 x green ≥ 2/3
Continuous lighting 2 x green ≥ 1/3
Continuous lighting 1 x green <1/3
Flashing light 1 x green Reserve
OBJ_BUCH-518-002.book Page 22 Tuesday, February 3, 2009 12:02 PM