Bosch FLEXIDOME corner 9000 MP, Руководство пользователя программного обеспечения

Страница: 55 / 108

Camera Browser Interface Encoder Settings | en 55
Bosch Security Systems Software manual AM18-Q0649 | v5.8 | 2013.06
GOP structure
Select the structure you require for the Group of Pictures
(GOP). Depending on whether you place greater priority on
having the lowest possible delay (IP frames only) or using as
little bandwidth possible, you choose IP, IBP or IBBP.
Averaging period
Select the appropriate averaging period as a means of
stabilizing the long term bit rate.
I-frame distance
Use the slider to set the distance between I-frames to Auto or
to between 3 and 60 . An entry of 3 means that every third
image is an I-frame.The lower the number, the more I-frames
are generated.
Min. P-frame QP
In the H.264-protocol, the Quantization Parameter (QP)
specifies the degree of compression and thus the image quality
for every frame. The lower the QP value, the higher the
encoding quality. A higher quality produces a higher data load.
Typical QP values are between 18 and 30. Define the lower limit
for the quantization of the P-frames here, and thus the
maximum achievable quality of the P-frames.
I/P-frame delta QP
This parameter sets the ratio of the I-frame QP to the P-frame
QP. For example, you can set a lower value for I-frames by
moving the slide control to a negative value. Thus, the quality of
the I-frames relative to the P-frames is improved. The total data
load will increase, but only by the portion of I-frames.
To obtain the highest quality at the lowest bandwidth, even in
the case of increased movement in the picture, configure the
quality settings as follows:
1. Observe the coverage area during normal movement in the
preview images.
2. Set the value for Min. P-frame QP to the highest value at
which the image quality still meets your needs.