Bosch EXTEGRA IP 9000 FX NXF-9x30, Руководство по установке

Страница: 20 / 60

Connections
Power Cable Requirements
!
Warning!
Before proceeding, disconnect the power from the power supply cable. Ensure that the
voltage of the unit matches the voltage and type of the power supply being used.
Connect power from a 24 VAC class 2 power supply. Use AWG 16 to 22 stranded wire or AWG
16 to 26 solid wire; cut back 5 mm (0.2 in.) of insulation.
Cable size Stranded wire: AWG 16 to 22
Solid wire: AWG 16 to 26
Cable shape Round
Conductors 2-conductor version
Environmental Outdoor rated
!
Warning!
Bosch’s version of High PoE:
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
The table below identifies the power devices that can be connected simultaneously to the
camera.
If power is supplied from: Camera can receive power simultaneously from:
60 W midspan (NPD-6001A)
24 VAC PSU
(VG4-A-PSU1, VG4-A-PSU2)
95 W midspan (NPD-9501A)
VIDEOJET connect (VJC-7000-90)
Wire Distance Guide
This table lists the maximum wire distances for 16 and 18 AWG wires for 24 VAC power.
16 AWG
(1.5 mm) 18 AWG
(1.0 mm)
With OFC Kit 40 m (131 ft) 25 m (83 ft)
Without OFC Kit 42 m (136 ft) 26 m (86 ft)
Ethernet Cable Requirements
Cable Type Cat5e/Cat6e Ethernet (directly to the camera, or to a network switch
between the camera and the network)
Maximum Distance 100 m (330 ft)
Terminal
Connector RJ45, Male
6
6.1
6.1.1
6.2
20
en | Connections EXTEGRA IP 9000 FX
2015.03 | 1.7 | F.01U.304.260 Installation Manual / Guide d'installation Bosch Security Systems