10
Operating procedure
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
❑
Keep pressing the
+
button until a
ç
appears in the display.
❑
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step
}
after 10 minutes.
Fan follow-on:
❑
Press the
button.
The fan continues to run at step
|
for 10
minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
❑
Briefly press the
a
button to switch the
light on and off.
❑
The light can be switched on at any
time, even though the fan is switched off.
❑
Adjusting the brightness:
Hold down the
a
button until the
desired brightness is obtained.
Switching on the light automatically, e.g.
via a timer:
❑
Fan and light must be switched off.
Switching on:
Simultaneously
press the
–
and
!
buttons.
❑
After approx. 3 seconds the light
switches on to acknowledge the setting.
Switching off:
Repeat the process with the light switched
on.
❑
After approx. 3 seconds the light
switches off to acknowledge the setting.
Grease filter:
two metal grease filters are inserted to
soak up the fatty remains of the kitchen
steam.
The filters are made of non-inflammable
metal.
Caution:
As the filter becomes more and more
saturated with grease, not only does the
risk of it catching fire increase but the
efficiency of the extractor hood can also be
adversely affected.
Important:
Danger of fire, which can occur through
the accumulation of heat when deep frying
or roasting, can be prevented by timely
cleaning.
Saturation indicator:
When the grease filters reach saturation
point, an acoustic signal is sounded for 10
seconds after the fan has switched off, and
an
#
appears in the display. The grease
filters should be cleaned straight away.
Cleaning the grease filter:
❑
The filters can be cleaned in a dish-
washer. It is however possible that they
will become slightly discoloured.
❑
Insert the outer filter so that the hooking-
in holes are at the bottom and the rinsing
water can run off.
Important:
Do not clean very soiled grease filters
together with dishes.
❑
When cleaning the filters by hand, soak
them in hot soapy water first of all.
Then brush the filters clean, rinse them
thoroughly and leave the water to drain off.
Cancel the
#
in the display.
❑
Press the
0
button.
Filters and maintenance
