10
PLACING THE DISHWASHER
1
Straighten and position the hot water supply line and
the electrical supply cable as shown in
Figure 18
so
that they will align with their channels under the
dishwasher base.
2
Position the dishwasher close enough to the enclosure
so that you can run the dishwasher drain hose to the
under sink drain connection. Make certain that the hot
water supply line and the electrical supply cable are in
their channels under the dishwasher base, as shown in
Figure 19
.
3
Slide the dishwsher into the opening making sure that
the hot water supply line and the electrical supply
cable stay in their proper channels.
4
Make sure the dishwasher is level. Adjust the rear
leveler by turning the center screw at the front of the
dishwasher, as shown in
Figure 20a
. Turning the screw
clockwise raises the rear of the dishwasher. Adjust the
front levelers by turning them with a screwdriver, as
shown in
Figure 20b
. Turning the levelers to the right
raises the dishwasher. If additional height is needed,
shims may be added under the leveler feet.
SECURING THE DISHWASHER
1
Drive the mounting screws through the holes in the
mounting brackets as shown in
Figure 21
for Top
Mount or Side Mount.
2
After the unit is installed in the enclosure, leveled and
secured, lock the two front leg levelers in place by
driving the enclosed leg leveler locking screws into
each screw boss located in front of the levelers. See
Figure 22
.
3
Tighten screws until they are flush with the surface of
the bosses.
Figure 21
Figure 20
a
b
Figure 18
21"
(533mm)
14"
(355mm)
Figure 19
Placing the Dishwasher/ Securing the Dishwasher
Top Mount
Side Mount
Figure 22
Leg
Leveler
Locking
Screw
Screw
Boss
Hot Water Supply Line
and Electrical Supply
Cable Position in
Channels