Bosch DFS097E50A, Инструкция по установке и эксплуатации

Страница: 16 / 20

en
Installation
16
Sliding out the appliance
Note:
Before you remove the appliance, protect the hob
with a piece of polystyrene from the packaging.
1.
Use a flat-blade screwdriver to push in the fastening
bolt, and turn it 90° until it locks into place.
¨
2.
Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing along
with the spring.
When doing this, grip the bottom of the appliance
with the other hand.
©
Caution!
Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing with the
spring.
3.
Carefully remove the appliance.
4.
Screw in the filler strip fully.
5.
Reinsert the springs and fastening bolts.
Note:
The mounting pieces on the left and right of
the appliance must be able to move.
Final fitting stage
1.
Slide the appliance up into place.
¨
2.
Lock the fastening bolts on the left and right.
©
3.
Fit the protective caps on the left and right.
ª
4.
Establish the electrical connection.
Note:
The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
■
The intermediate floor must not be placed on the
extractor hood's housing.
■
The front panel must not be secured to the housing.
■
Access must be available in order to change the
filter and for the after-sales service.
$ %
ƒ ƒ
[