1 689 989 485 | 2020-08-01
Robert Bosch GmbH
1
2
33
4712005-45_shd
(1) Front cover
(2) Positioning unit
(3) Knurled screws for height adjustment
4. Insert the new positioning unit into the edge protec‐
tion frame and secure it at the required height by
means of the knurled screws.
5. Attach the cover to the edge protection frame.
---Separator---
6.4
Replacing the magnets on the indica‐
tor bar
1. Loosen the screws
(1)
on the indicator bar and re‐
place both magnets
(2)
.
If only one of the magnets is replaced, the indica‐
tor bar will be held to the DAS 3000 S20 by mag‐
nets with different forces. To ensure a sufficiently
strong magnetic force and prevent damage from
parts dropping, it is always necessary to replace
both magnets.
2. Attach magnets with a maximum tightening torque of
0.5 Nm.
If the magnets are attached with a tightening tor‐
que greater than 0.5 Nm, the magnets and the in‐
dicator bar can be damaged.
11
22
4712005-54_shd
(1) Screws
(2) Magnets
---Separator---
6.5
Replacing slides and end caps of the
slide guide on the indicator bar
1. Remove the end cap from the slide guide with the
aid of a pliers.
— Make sure that the spring in the end cap does not
drop out when the end cap is being removed.
If the spring drops out and is lost, the end cap
can no longer be attached to the slide guide.
2. Remove the slide with stop from the slide guide.
3. Push the new slide with stop into the slide guide in
such a way that the mounting pin points inwards.
If the slides are pushed into the slide guide with
the mounting pin pointing outwards, the calibra‐
tion board will be rotated by 180° when fastened
to the indicator bar. The front camera calibration
will fail.
4. Attach the end cap to the slide guide.
1
2
3
4
4712005-42_shd
(1) Slide with stop
(2) Slide guide
(3) End cap
(4) Spring in the end cap
---Separator---
6.6
Replacing the arrestor cable on the
slides
1. Remove the screw from the slide with stop
(1)
.
2. Remove the arrestor cable
(2)
and attach new ar‐
restor cable.
3. Secure the cable with the screw.
1
2
4712005-43_shd
(1) Slide with stop
(2) Arrestor cable
---Separator---
en | 34 | DAS 3000 S20
