Bosch D720, Руководство пользователя

Страница: 21 / 34

20
Fire Test
❒
I have this feature.
❒
I do not have this feature.
❒
This feature requires a passcode.
Use this function to lest fire points and other 24-hour points to be certain
they function properly. You can review untested points at your command
center to help pin-point any problems.
Upon initiation, the fire test will test the fire bell pattern on the bell output
and ring the command center fire bell for 2 seconds. The AC will be
disabled for 4 minutes in order to test the system’s battery power. If the
battery cannot maintain the system for the 4 minute period, the command
center will appear to go dead. If this happens, contact your security
company. At the end of the 4 minute period, AC is returned to the system
and the panel restores. A message will be sent to your security company
upon initiation and completion of the fire test. During the fire test, no
24-hour alarms will be sent to your security company.
If there is no activity on the system for 20 minutes, the system will
automatically exit from the fire test.
COMMAND 5 8
To use Fire Test:
1. Ensure that your security system is idle.
2. Press the COMMAND bar. The Command Mode indicator light comes
on.
3. Press the 5 key, and then the 8 key. Audible devices (both interior and
exterior) sound the fire bell.
4. One-at-a-lime, activate the detection devices to fault each point. The
audible fire devices sound momentarily, and the command center
display indicates the point you’ve faulted. This verifies that the
detection device is working properly.
5. To end the fire test, press any numeric key on the Command Center. If
no activity occurs on the system for 20 minutes, the fire test will end
automatically.