D2212B/D2212BE Operation and Installation Guide
D2212B/D2212BE
Page 21
© 2002 Bosch Security Systems
39934E
5.0
Telephone Connections
5.1
Phone Jack
To prevent jamming of reports, wire the RJ31X jack before the in-house phone system to support line seizure (see Figure 7).
Line seizure provides for a temporary interruption of normal phone usage while the communicator transmits data.
After installation, confirm that the panel seizes the line, acquires dial tone, reports correctly to the receiver, and releases the
phone line to the in-house phone system.
Figure 7: RJ31X Phone Jack
5.2
Phone Cord
Connect the flying leads of the D160 or D164 Phone Cord to the panel as shown in Figure 8. Connect the modular end to the
RJ31X.
To RJ31X
Phone Jack
D164
Phone Cord
Black, Yellow,
Orange, and
Blue not used.
R
R1
T1
T
Brown
Green
Red
Gray
Figure 8: Phone Cord
5.3
Power Up
Connect the battery and then plug in the transformer. Leave the Standby Switch locked down for now.
5.4
Program the Panel
Use the keypad, Bosch Security Systems D5200 Programmer, or a remote programmer to program the panel. See the D2000
Series Program Entry Guide (P/N: 35114) for programming options and keypad programming instructions.
If you are programming from the keypad or using the D5200, make sure the Standby Switch is locked down. See
Figure 10
on page 22.
If you’re using the D5200, Figure 9 on page 22 shows the location of the programming jack. See the D5200 Programming
Operation Guide (P/N: 74-06176-000) for instructions on using the programmer.
Telephone Connections
1
2
3
4
5
6
7
8
Incoming
Telco Line
R
T
R1
T1
Full Modular Phone Jack
Premises Phone
RJ31X Module
