Bosch CMG676BS6B, Инструкция по эксплуатации

Страница: 21 / 48

en Steam
20
Notes
■
If the water tank runs out of water during cooking,
the appliance will continue cooking, but without
steam assistance. No indicator will appear on the
display.
■
Opening the appliance door affects the cooking
result. Always keep the appliance door closed when
cooking.
The cooking time has elapsed
A signal sounds and the start
l
stop symbol stops
lighting up. Combination mode has finished. Touch any
field to end the acoustic signal.
Changing the steam level
Touch the
"
field until the required level is selected in
the display.
Note:
Touch the field multiple times switches through
the levels from the highest to the lowest level. After the
lowest level, the steam function is deactivated.
Touching again activates the steam function, starting
with the highest level.
Pausing the operation
1.
Touch the start
l
stop field or open the appliance
door.
The operation is suspended and the
start
l
stop LED flashes.
2.
Close the appliance door.
3.
Touch the start
l
stop field.
The operation is continued and the start
l
stop LED
lights up.
Stopping the appliance from heating
Turn the function selector to the "Off" position.
The appliance will stop heating and all the settings will
be cleared.
Note:
The fan may continue to run after the appliance
has been paused or stopped.
Filling the water tank
Filling the water tank
The water tank is located to the right behind the tank
cover, below the appliance door. Before starting an
operation with steam, open the tank cover and fill the
water tank with water.
Ensure that the water hardness range has been set
correctly.
~
"Basic settings" on page 28
:
Warning – Risk of injury and fire!
Only fill the water tank with water. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>40 mg/l) or other liquids.
Only use fresh, cold, non-carbonated tap water or
softened water.
Notes
■
If your water is very hard; we recommend that you
use softened water.
■
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
1.
Briefly press on the centre of the tank cover.
The tank cover will open. The drip tray (left) and
water tank (right) can now be accessed.
2.
Remove the water tank from the tank recess.
3.
Fill the water tank with cold water up to the "max."
mark.
4.
Place the water tank back into the tank recess and
slide it in fully.
5.
Close the tank cover.
The steam function is ready to use.
1 2
Steam en
21
Refilling the water tank
The way the appliance responds if the water tank runs
dry when the appliance is in operation depends on what
operating mode it is in:
■
Steam-assistance mode: The appliance is stopped
and a message appears on the display.At the
highest steam setting, a tankful of water will last
approx. 30-40 minutes; at the lower steam settings,
it will last much longer.
■
Steam-assistance with microwave: The appliance is
stopped. A tankful of water will last approx.
50 minutes.
■
Steam-assisted hot-air or grill mode: The appliance
continues to run in hot-air or grill mode; no message
appears on the display. At the highest steam setting,
a tankful of water will last approx. 3 hours; at the
lower steam settings, it will last much longer.
■
Steam-assisted air recirculation grill mode: The
appliance continues to run in air recirculation grill
mode; no message appears on the display. A tankful
of water will last approx. 9 hours.
Note:
Actual times may vary from those specified.
Refill the water tank up to the "MAX" mark.
1.
Open the control panel.
2.
Remove and refill the water tank.
3.
Insert the filled water tank and close the control
panel.
After every steam operation
Moisture remains in the cooking compartment. Carefully
wipe out the drip channel and the cooking
compartment. Each time you cook using steam, we
recommend that you run the Rinse cleaning function
!
afterwards. Then empty and dry the water tank and drip
tray.
Note: Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a soft
cloth.
Rinsing
To ensure that your appliance stays clean, you can
pump water through the pipe system. The water is then
drained to the drip tray.
Note:
After rinsing, there can be dissolved lime
particles in the drip tray. This is normal and does not
affect operation.
Starting
1.
Use the function selector to select the rinse cycle
!
.
The duration of the programme will be displayed.It
cannot be changed.
2.
Open the tank cover.
3.
Remove and empty the drip tray.
4.
Slide the empty drip tray in fully.
5.
Remove water tank and drain any residual water.
Rinse out water tank thoroughly and fill with fresh
water.
6.
Slide the water tank in fully.
7.
Close the tank cover.
8.
Touch the start
l
stop button.
Water is pumped through the pipes.The time
remaining will count down on the display. An audible
signal will sound once this time has elapsed. Empty
the drip tray.
Emptying the water tank
1.
Briefly press on the centre of the tank cover.
The tank cover folds upwards.
2.
Remove the water tank.
3.
Carefully remove the lid for the water tank.
4.
Empty the water tank, clean it with detergent and
then rinse it thoroughly with clean water.
5.
Dry all parts with a soft cloth.
6.
Rub the seal on the lid until dry.
7.
Allow the water tank to dry with the lid open.
8.
Place the lid on the water tank and push down on it.
9.
Slide the water tank in fully.
10.
Close the tank cover and briefly press on the centre
of it.
The tank cover is locked.
Caution!
■
Do not dry the water tank in the hot cooking
compartment. This will damage the water tank.
■
Do not clean the water tank in the dishwasher. This
will damage the water tank.
Cleaning the drip trough
1.
Allow the appliance to cool down.
2.
Open the tank cover.
3.
Remove the water tank and drip tray.
4.
Wipe around the drip trough ‚ underneath the
cooking compartment with a sponge cloth (fig.
!
).
Drying the cooking compartment
Dry the cooking compartment after operation to ensure
that no moisture remains.
Heating up the cooking compartment
To dry, heat up the cooking compartment so that the
moisture in the cooking compartment evaporates. Then
open the appliance door to allow the steam to escape
from the cooking compartment.
1.
Allow the appliance to cool down.
2.
Remove the worst dirt from the cooking
compartment immediately and wipe away moisture
from the cooking compartment floor.
3.
Use the function selector to select Hot air grill
4
D
1