Installation Manual
Bosch Climate 5000 AA Series Inverter Multi Split-Type Ductless Air Conditioner / Heat Pump
| 9
Bosch Thermotechnology Corp.
|
01.2017
Data subject to change
6 Outdoor unit installation
Step 1: Select installation location
The outdoor unit should be installed in the location that meets the following
requirements:
Place the outdoor unit as close to the indoor unit as possible.
Ensure that there is enough room for installation and maintenance.
The air inlet and outlet must not be obstructed or exposed to strong wind.
Ensure the location of the unit will not be subject to snowdrifts,
accumulation of leaves or other seasonal debris. If possible, provide an
awning for the unit. Ensure the awning does not obstruct airflow.
The installation area must be dry and well ventilated.
There must be enough room to install the connecting pipes and cables and
to access them for maintenance.
The area must be free of combustible gases and chemicals.
The pipe length between the outdoor and indoor unit may not exceed the
maximum allowable pipe length.
If possible, DO NOT install the unit where it is exposed to direct sunlight.
If possible, make sure the unit is located far away from your neighbors’
property so that the noise from the unit will not disturb them.
If the location is exposed to strong winds (for example: near a seaside), the
unit must be placed against the wall to shelter it from the wind. If necessary,
use an awning. (See Fig.4 & 5)
Strong wind
Strong wind
Figure 4
Strong wind
Figure 5
Install the indoor and outdoor units, cables and wires at least 3ft from
televisions or radios to prevent static or image distortion. Depending on the
radio waves, a 3ft distance may not be enough to eliminate all interference.
Step 2: Install outdoor unit.
CAUTION:
Be sure to remove any obstacles that may block air
circulation.
Make sure you refer to Length Specifications to ensure there
is enough room for installation and maintenance.
Fix the outdoor unit with anchor bolts (M10).
>23.6" / 60cm
Fix with bolts
Figure 6