CC484/CC486/CC488 |
Operators Manual | 20.
Domestic Dialling
EN
| 16
Bosch Security Systems | 3/04 | SUB-MA48XO-3318
19.1 Master Partitioned Codepad
Indicators
The indicators on a Master Partitioned codepad
are configured into four groups (such as Zone
Indicators, Area On/Off Display, Area Display,
and Status Indicators). See
Figure 6
.
Figure 6: Master Partitioned Codepad
19.1.1 Zone
Indicators
Zone indicators 1 to 8 show the status of each
zone. These zones belong to the area that has the
Area Display indicator lit. For example, if an
indicator is lit, that zone is unsealed. If the
indicator is dark, that zone is sealed.
19.1.2
Area On/Off Indicators
The group of four Area On/Off indicators display
the status of each area. For example, if an
indicator is lit, that area is armed. If the indicator
dark, that area is disarmed.
Only Area 1 and Area 2 can be used
with the Solution Ultima 880 Control
Panel.
19.1.3
Area Display Indicators
The group of four AREA DISPLAY indicators
show which area the zones displayed belong to.
19.1.4 Status
Indicators
A group of four indicators display the following:
AUX Indicator
Displays when the control panel is using the
telephone line communicating to the receiving
party.
MAINS Indicator
Displays the status of the AC mains power. (For
example, if the indicator is illuminated, the AC
mains power supply is normal. If the indicator is
flashing, the AC mains power supply is
disconnected or failed.)
FAULT Indicator
Displays the status of the fault register. (For
example, if the FAULT indicator is flashing, the
system detected a fault that is not yet
acknowledged. If the FAULT indicator is
illuminated, the fault is acknowledged. If the
FAULT indicator is not illuminated, the system
has no faults.)
PARTIAL Indicator
Only displays when an area is armed in STAY
Mode 1. (For example, if the PARTIAL indicator
is displayed, an area is armed in STAY Mode 1. If
the PARTIAL indicator is not displayed, no areas
are armed in STAY Mode 1.)
19.2 Operation of Codepads in
Partitioning
Area Addressable Codepad Operations
If you have a system partitioned with Area
Addressable eight-zone codepads, the operating
procedure is the same as described for a non-
partitioned system, except that all operations only
relate to the area the codepad is assigned to.
Master Partitioned Codepad Operations
If your system is partitioned with a Master
Partitioned codepad installed, the operating
procedure is the same as described for a non-
partitioned system, except that all operations relate
to the area displayed by the Area Display
indicator.
Example
If the Area Display indicator displays number 2,
all operations performed only operate in Area 2.
To operate Area 1, you must toggle the Area
Display indicator to number 1 by pressing the [#]
key. Pressing the [#] key again toggles you back to
the Area 2 display.
20. Domestic Dialling
Use domestic dialling can be used to call your
mobile phone or a relative/friend if your control
panel activates an alarm. Up to three different
telephone numbers can be programmed for the
control panel to call when an alarm occurs. Only
your installer can program the system to report in
the domestic format. The Master Code holder can
change the telephone numbers at any time.
20.1 Acknowledging Domestic Calls
When an alarm condition occurs, the system calls
the first programmed telephone number. When
you answer an incoming call, the system
repeatedly emits a siren tone followed by a pause,
continuously for 2 minutes (for example, siren
tone, pause, siren tone, and pause).
