Bosch B810-CHI, Руководство по установке, Страница: 23 / 96

RADION receiver SD RADION receiver SD | en 23
Bosch Security Systems B.V. 2020.05 | 13 | F.01U.261.834
Configuring the address switch
This switch determines the receivers numeric address value
which the receiver will use to report receiver status information
to the control panel. Set the address to the receiver prior to
installation. Address 1 through 4 are valid address settings for
the receiver. Use a slotted screwdriver to set the address
switch.
Address settings
The receiver switches provide a single-digit setting for the
receiver’s address. Addresses 0 and 5 are invalid and will cause
the receiver to enter into an SDI2 communication error state.
This causes the receiver to be unrecognized by the control
panel. The receiver uses Address 9 to reset itself when the
keyfob becomes inoperable. Refer to the Notice below and
procedure regarding the synchronization of the keyfob with the
receiver.
Refer to your control panel documentation for information on
the valid addresses for that control panel. The figure below
shows the address switch setting for address 1.
Figure 3.1: Address switch set to 1
Notice!
Inoperable RADION keyfob
If the RADION keyfob no longer operates as originally
programmed, try resetting the receiver. RF IDs remain active if
previously enrolled, and will not have to be re-enrolled when
resetting the receiver.