Bosch B426, Инструкция по установке и эксплуатации

Страница: 10 / 38

10 en | Installation Conettix Ethernet Communication Module
2016.08 | 08 | F.01U.266.226 Installation and Operation Guide Bosch Security Systems, Inc.
4 Installation
After you set the address switch for the proper address, install the module in the enclosure
and then wire the module to the control panel and to the Ethernet connection.
4.1 Mount the module in the enclosure
Mount the B426 into the enclosure’s 3-hole mounting pattern using the supplied mounting
screws and mounting bracket.
For UL certified systems, mount the module in the control panel enclosure or in a UL listed
enclosure (for example, the D8103 Universal Enclosure).
House all communicators in tampered enclosures, compliant with the following clauses within
Standard CAN/ULC-S304-06: 5.2.6; 5.2.9; 5.2.10 and 5.2.15.
3
1
2
Figure 4.1: Mounting the module
Callout
ᅳ
Description
1
ᅳ
B426 with mounting bracket installed
2
ᅳ
Enclosure
3
ᅳ
Mounting screws (3)
4.2 Mount and wire the tamper switch (optional)
For B9512G/B8512G, B6512/B5512/B4512/B3512, and GV4 v.2xx control panels, you can
connect an enclosure door tamper switch for one module in an enclosure.
Installing the optional tamper switch for use with a B426:
1.
Mount the ICP-EZTS Cover and Wall Tamper Switch (P/N: F01U009269) into the
enclosure’s tamper switch mounting location. For complete instructions, refer to the
Cover and Wall Tamper Switch (ICP- EZTS) Installation Guide (P/N: F01U003734).
2. Plug the tamper switch wire onto the module’s tamper switch connector. For the tamper
switch connector location, refer to B426 module overview, page 8.
4.3 Wire to the control panel
When you wire a B426 to an SDI or SDI2 control panel, you can use either the module's
terminal strip labeled R, Y, G, B (PWR, A, B, COM) or the module's interconnect wiring
connectors (wire included). The figure below indicates the location of both the terminal strip
and the interconnect wiring connectors on the module.