Bosch Autodome Inteox 7000i-2MP, Руководство по установке

Страница: 18 / 44

18 en | Installing the In-Ceiling Mount AUTODOME inteox 7000i - 2MP (in-ceiling)
2021-08 | 1.4 |
Installation Manual
Bosch Security Systems
7 Installing the In-Ceiling Mount
7.1 Description
This chapter details how to install the camera in an in-ceiling mount. The in-ceiling
AUTODOME camera is suitable for use in environmental air spaces.
To install the In-ceiling Mount, verify that a minimum of 216 mm (8.5 in.) of air space above
the ceiling is available.
7.2 Dimensions
206.89
[8.145]
175.99
[6.929]
21.29
[0.838]
99.76
[3.928]
IP
78.04
[3.072]
IP
204.49
[8.051]
ø
74.65
[2.939]
HD
95.88
[3.775]
HD
mm
[in.]
ø
Figure 7.1: AUTODOME 7000 Dimensions – In-ceiling
7.3 Prepare Drywall Ceiling for Installation
1. Choose the desired location to mount the camera.
2. Use the bracket Base Plate as a template to cut a 7 in. hole with a tolerance of ±1/8 in.
(177.8 mm ±2.2 mm) in the ceiling with a drywall utility saw or Jig Saw. Proceed to Wire
the Interface Box, for further instructions.
7.4 Preparing the Suspension Ceiling for Installation
You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1.
Choose the desired location to mount the camera.
2. Remove an adjacent ceiling tile.
3. Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
4. Place the Bracket Assembly over the ceiling tile, which is used to mount the camera.
5. Snap the Bar Clips of the bracket to the ceiling rails.