Bosch AutoDome 100 Series, Руководство пользователя

Страница: 16 / 20

16 en | Troubleshooting Guide AutoDome 100 Series Fixed Camera
F.01U.216.346 | 1.0 | 2011.04 User Manual Bosch Security Systems, Inc.
Inside of
EnviroDome bubble
is foggy
– Check the status of the Heater Module ( ON - 66 - ENTER ).
If status reports Heater No Power, then:
– Turn off the power to the AutoDome.
– Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.
If O.K., then:
– Check all wiring and connector pins to the heater module.
Low Voltage flashing
on monitor display
– If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power
ratings. See the AutoDome Datasheet for specifications.
If O.K., then:
– Check the mains input line voltage.
If O.K., then:
– Check that the maximum wire length from the power supply has not been exceeded.
See the
VG5 AutoDome Installation Manual
.
If O.K., then:
– Measure the AC voltage input to the camera while power is applied to the camera. The
voltage must be ≥ 21 VAC to stop the message.