English |
9
Bosch Power Tools
2 609 140 527 | (9.6.08)
Technical Data
Assembly
Battery Charging (see figure A)
f
Use only the battery chargers listed on the
accessories page.
Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note:
The battery is supplied partially charged.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against deep
discharging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Do not continue to press the
On/Off switch after the ma-
chine has been automatically switched off.
The
battery can be damaged.
To remove the battery
8
, press the unlocking but-
tons
7
and pull out the battery downwards.
Do
not exert any force.
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Changing the Tool (see figure B)
f
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion.
Unintentional actuation of the On/Off
switch can lead to injuries.
Hold the rear sleeve
3
of the keyless chuck
1
tightly and turn the front sleeve
2
in rotation di-
rection
n
, until the tool can be inserted. Insert
the tool.
Hold the rear sleeve
3
of the keyless chuck
1
tight
and firmly turn the front sleeve
2
in rotation di-
rection
o
by hand.
Replacing the Drill Chuck
For power tools without spindle lock, the drill
chuck must be replaced through an authorized
after-sales service agent for Bosch power tools.
The drill chuck must be tightened with a
tightening torque of approx. 20–25 Nm.
Cordless Drill/Driver
GSR 10,8 V-LIQ
Professional
Article number
3 601 J92 2..
Rated voltage
V=
10.8
No-load speed
rpm
0
–
500
Max. torque for
hard/soft screwdriv-
ing application ac-
cording to ISO 5393
Nm
18/7
Max. drilling dia.
– Steel
– Wood
mm
mm
6
18
Max. screw dia.
mm
6
Chuck clamping range
mm
0.8
–
6.0
Drill spindle thread
1/2"
Weight according to
EPTA-Procedure
01/2003
kg
0.9
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
WARNING
OBJ_BUCH-756-002.book Page 9 Monday, June 9, 2008 2:18 PM
